HOME and how to join Forum Open Area General Scott topics Gearbox indent plates Re: Re: Gearbox indent plates

#16896
grollinson
Participant

I’ve just been reading Scott Technicalities regarding my own problems and notice that ‘A Beginners Guide to the Scott Gearbox’ by a certain Brian Marshall (V16 12 Oct 1990) says that ‘Problems can occur when people lose the ballbearing out of the selector bellcrank lever. They unwittingly replace it with a 1/4″ ballbearing instead of the correct 9/32″ bearing, and then get mysterious selection problems!’

Which is correct please, 9/32″ or 7/32″ as stated in the above post?

Regards

Graham