HOME and how to join Forum Open Area General Scott topics Vintage Super Front Forks Re: Super forks

#5920
Roger Moss
Participant

The concept of these forks has always frightened me and I have been surprised that they lasted as long as they have.
I raced Clive Waye’s bike a couple of times and was very conscious of the possible consequences of a breakage.
They must all now be suffering from stress fatigue, this is monitored on airframes but not road vehicles. Forks, cranks, same problem.
We were recently brought a set of these forks and will be making a good study and will formulate the design of an appropriate repair.
The main difficulty is not whether it can be done, but what margin of safety is prudent and what cost implications are acceptable.
If I were to do it for myself, I would make the stem from 300M VAR (S155) which is what we use for cranks and is what, I understand, Airbus now use for their landing gear legs. This must be at least 300% stronger than the original steel with a higher fatigue resistance. The inner expanding section that locks the bars, would be taken down to the bottom with a good fit, to further reinforce the whole lower stem section.
Now we come to the yolk! Remove the paint and examine and most will have cracks here. Considering the leverage and bursting loads, especially considering the use over years, it would be very surprising if there were not
You might make a repair by brazing on a plate, as long as it is wide, but I tell you honestly, I would not do it for myself if I were to contemplate spirited riding, significant potholes or emergency stops.
I would be happier to remake the whole yolk out of a suitable high tensile steel blank.
Perhaps make the stem hole in the yolk tapered with its larger end at the bottom. The stem would have a matching taper and would be driven in and secured.
We had considered a malleable iron casting for the yolk as originally done, but until we had enough data to be sure that the material gave a sufficient margin of improvement, it would remain a subject for investigation, rather than a recommendation.
Conclusion. There is no engineering problem that cannot be solved, but there are solutions that are unrealistic in cost terms, depending on the owner’s personal circumstances and dedication to retain Alfred’s original design.
It’s all about cost!