Flyer clutch centre hub | Scotts Owners Club

This topic has 2 replies, 2 voices, and was last updated 8 years, 11 months ago by scott596.

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
4th November 2014 at 5:46 pm #3872

scott596
Participant

I am about to make a small batch of Flyer clutch centres this is the hub that carries the steel plates, they will cost £100 each. If anyone is interested please let me know. Alan Noakes. scottworkshop@hotmail.co.uk

8th November 2014 at 3:03 pm #12863

BRIAN MARSHALL
Participant

Hi Alan,
What material are you intending to use ? And will they be case hardened to stop the tongues on the plates hammering into the slots ?
Regards,
Brian

8th November 2014 at 4:45 pm #12864

scott596
Participant

Hi Brian I intend to use alloy steel hardened and tempered. Alan noakes. scottworkshop@hotmail.co.uk
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.