Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: First ride #9174
    DavePanther
    Participant

    Bike passed MOT today,went too local DVLA office on “Panther” for tax disc,completed a ride of about 20 miles on “Scott”,bit of bad news drained oil from crankcases,r.h clear but very small amount of brass/bronze filelings in left,any ideas on possible source?I was thinking the gudgeon pin area!
    cheers
    Dave

    in reply to: Dowty forks #9151
    DavePanther
    Participant

    There is no evidence on the cowls or rings of any previous brazing/solder,but its still a good idea and will silver solder at work tomorrow.
    Cheers
    Dave

    in reply to: Dowty forks #9149
    DavePanther
    Participant

    Hi Eddie
    I purchased the seals from the club spares,my cowls do not have annular groves but about 22mm from top edge of cowl there is a series of 6 dot punch nibs about .5mm deep on the inside!could this be to support the brass ring and the lip seal sits on this?,then were dose the plan rubber ring go.
    Still no luck att. pictures any one advise on how to do it.
    Cheers
    Dave

Viewing 3 posts - 1 through 3 (of 3 total)