[Michelle Pollus]

Hi Chris,

I thought i read a forum post either here or google forum but at this point I can check yowl….thx Sir..

Joe

[Michelle Pollus]

Thanks for input….making most of the cables so they will not be an issue.

Just was not sure if spring was close to stock item…Joe

[Michelle Pollus]

Hi,

Was hoping to flip but cracked edges in a few locations…

Found a thrust washer for roller thrust bearing but i have to rework.

Was hoping I could find one without grinding one on my lathe….

Doug can you tell me where they are available?

Joe

[Michelle Pollus]

Hi,

Was hoping to flip but cracked edges in a few locations…

Found a thrust washer for roller thrust bearing but i have to rework.

Was hoping I could find one without grinding one on my lathe….

Doug can you tell me where they are available?

Joe

[Michelle Pollus]

Detent plate.

Attachments:

You must be logged in to view attached files.

[Michelle Pollus]

Hi,

Finished up detent plate a few weeks ago. First i should have known that fit and finish was not yet perfected and one detent plate is not the same as others. Mount holes and arc were not the same so I removed gearbox and started frim square one. After mounting plate I marked box with black magic marker and with heaviest spring and ball i selected each gear at best engagement point and tapped on arm to make mark in plate. Then center punched and drilled 1/8″ hole (approximately 1/16″) then finished up with a bit smaller than the 9/32 ball to a proper depth to seat ball ( aprox .100″ as i remember). All seems good now.

On to replacing worn out clutch actuation thrust washer as it is in horribly condition.

Attachments:

You must be logged in to view attached files.

[Michelle Pollus]

Hi Guys,

So a “Moss” crank is an aftermarket or modified crankshaft assembly?

From Chis’s post it seems to be adequate for this crankshaft so I will move on to the next issue on my list.

Appreciate the help and time from all…

Happy New year , hope its a great one for all..

Joe

 

[Michelle Pollus]

Hi Scotty,

Appreciate all your help/time it is exactly what i need to make one without guessing position and spacing of detents…

Have a great day…Joe

[Author]

Posts